Builders, plumbers, electricians, HVAC and fit-out businesses

Trade supplier invoices, straight onto the job

Merchant invoices arrive with dozens of lines. Invoice Flow reads every one, sends the bill to Xero and puts the costs on the right WorkflowMax job, so the person running the job sees them straight away.

One invoice, start to finish

Typed in by hand, this invoice takes about 28 minutes (the bill, then the job costs again). Invoice Flow has read it before you open it: you check it and approve.

How it works for trades and construction

The merchant emails it

Invoices go to your Invoice Flow address, or you upload them. PDFs, photos of dockets and zips all work.

Every line is read

Each line, the GST and the totals are read and checked. A purchase order number on it finds your purchase order and suggests its job.

You check and approve

Pick the job for the whole invoice or line by line. Accounts come from your Xero history, and markup is worked out for you.

Bill and job costs, together

The bill goes to Xero and the costs go onto the WorkflowMax job with the PDF, then both are read back.

Why trades and construction use it

Made for the invoices you actually get

  • Long merchant invoices read in full, never summarised.
  • One invoice split across several jobs and phases, checked to add up before it's sent.
  • Your markup on every cost, from the workflow's default or set per invoice.
  • Job costs only go to WorkflowMax once the bill is in Xero, so the two never disagree.
  • A supplier that's new to WorkflowMax is added for you.
  • Duplicates checked in Xero and WorkflowMax before anything is sent.
  • Purchase order numbers on the invoice matched to your purchase orders, and the purchase order billed in WorkflowMax instead of doubling up job costs.

Time back each month

70 hours

At about 28 minutes each to type in by hand, the same rule the Time saved figure in the app uses: 6 minutes a bill, 1 a line after the first, and 3 to enter it again as job costs.

Questions

Can one merchant invoice go to several jobs?

Yes. Each line can go to its own WorkflowMax job and phase, and the job costs are checked to add up to the invoice before they're sent.

Does it add my markup?

Yes. Each workflow has a default markup, you can change it per invoice, and the billable amount is shown on every line before you approve.

Do I need WorkflowMax?

No. Invoice Flow works with Xero on its own. Connect WorkflowMax when you want supplier costs on your jobs, and choose per supplier where invoices go.

What if the invoice has 100 lines?

Every line is read. You can send them all, or have each workflow send one line per job, account and tax rate with the total.

Try it on your own invoices

25 free documents, no card needed.

Get started free